Connecting The Power Plug - JUKI APW-896/IP-420 Instruction Manual

5. CONNECTING THE POWER PLUG

CAUTION
:
To prevent possible accidents caused by leakage or dielectric strength, an appropriate power plug
shall be installed by a person who has an expert knowledge of electricity. Be sure to connect the
power plug to the receptacle that is well grounded.
Connection of the power plug to the power depends on the specifications of the product. Adjust the
power plug to the power specifications to connect.
1 In case of the product of single-phase, 200 to 240V specifications :
Connect the sky-blue and brown wires of the power cord to the power terminal (AC200 to 240V)
and the yellow/green wre to the ground (earth) termnal respectvely.
2 In case of the product of 3-phase, 200 to 240V specifications :
Connect the red, white and black wires of the power cord to the power terminal (AC200 to 240V)
and the yellow/green wre to the ground (earth) termnal respectvely.
3 In case of the product with the optional high voltage transformer (with SA-128) :
Connect the black wires (3 pieces) of the power cord to the power terminal (AC380 to 415V) and
the yellow/green wre to the ground (earth) termnal respectvely.
It is possible to connect to 380/400/415V by setting of the input tap of transformer (standard setting
at the time of delivery : 380V).
This product performs operation by the single-phase connection for 3-phasse 380/400/415V.
[Caution when changing the power source of the high voltage optional transformer]
1
When using high voltage optional transformer
1 with the input voltage of 400V or 415V, it is
necessary to replace nput power source cord 2
2
of high voltage optional transformer 1 . Change
power source nput cord 2 (sky blue) that s
connected to 380V to the connection of 400V or
415V.
To prevent accidents, perform the work
after leaving the sewing machine alone
more than 4 minutes in the state that the
power switch is turned OFF and the power
cord is drawn out.
High voltage optional transformer 1 s set on the
rear side of the table.
3
When performing changeover of voltage, remove
transformer box 4 after removing top cover 3 .
4
− 6 −