Tuning Step Selection - Icom IC-2300H Instruction Manual

Previous view
2
SETTING A FREQUENCY

■ Tuning step selection

The tuning step is the smallest selectable frequency
increment you can set the operating frequency. The fol-
lowing tuning steps are selectable.
• 5 kHz • 6.25 kHz • 10 kHz • 12.5 kHz • 15 kHz
• 20 kHz • 25 kHz • 30 kHz • 50 kHz
NOTE: For convenience, select the tuning step that
matches the frequency intervals of the repeaters in
your area.
q If necessary, push [V/MH z] to select the VFO mode.
w Push [SET] to enter the Set mode.
e Push [SET] or [MONI] several times, until "TS" ap-
pears, as shown to the right.
r Rotate [DIAL] to select the desired tuning step.
t Push any key, other than [SET] or [MONI], to save
the entry and exit the Set mode.
Using the HM-133V
z If necessary, push [VFO]
mode.
x Push [SET]
to enter the Set mode.
c Push [SET]
or [ENT]
appears.
v Push [Y] or [Z] to select the desired tuning step.
b Push [CLR]
to save the entry and exit the Set
mode.
to select the VFO
several times until "TS"
6
15 kHz tuning step
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz