Programming Memory Channels - Icom IC-2300H Instruction Manual

Previous view
QUICK REFERENCE GUIDE

■ Programming memory channels

The IC-2300H has a total of 207 memory channels for
storing often used operating frequencies, repeater set-
tings, and so on. Memories include 6 scan edges and
1 Call channel.
1. Setting the frequency
In the VFO mode, set the desired operating frequency,
repeater, tone and tuning steps, and so on.
2. Selecting the memory channel
Push [S.MW], and then rotate [DIAL] to select the de-
sired memory channel.
• The " " icon and memory channel number blink.
3. Writing a memory channel
Hold down [MW] (S.MW) for 1 second to program.
• 3 beeps sound
• The memory channel number automatically increases
when continuing to hold down [MW] (S.MW) after pro-
gramming.
Using the HM-133V
z In the VFO mode, set the desired operating frequen-
cy, offset and direction, tone settings, and so on.
x Push [FUNC]
then [MW]
• The " " icon and memory channel number blink.
c Push [Y] or [Z] to select the desired memory chan-
nel.
v Push [FUNC]
then hold down [MW]
ond to save the setting.
• 3 beeps sound
• The memory channel number automatically increas-
es when you continuing to hold down [MW]
programming.
.
for 1 sec-
after
vii
[DIAL]
[S.MW] (MW)
Push ,
MUTE
NAR
MID
LOW
then
LOCK
S ET
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET
MONI LOW TONE M/CALL V/MHz
DIGITAL PRIO AO BUSY
ANM DUP T-SCAN PRIO SCAN
MONI LOW TONE M/CALL V/MHz