I Tuning Step Selection - Icom IC-V8000 Instruction Manual

I Tuning step selection

Tuning steps are the minimum frequency change increments
when you rotate the tuning dial or push [Y]/[Z] on the micro-
phone. The following tuning steps are available.
• 5 kHz • 10 kHz
• 20 kHz • 25 kHz
NOTE: For convenience, select a tuning step that matches
the frequency intervals of repeaters in your area.
[SET(LOCK)] Tuning dial
[MW(S.MW)]
15 kHz tuning step
SET MODE
USING
• 12.5 kHz • 15 kHz
• 30 kHz • 50 kHz
q Push [V/MHz(SCAN)] to se-
lect VFO mode, if neces-
sary.
w Push [SET(LOCK)] to enter
set mode.
e Push
[SET(LOCK)]
[MW(S.MW)] several times
until "TS" appears as shown
below.
• Cancel the DTMF memory
function in advance, if neces-
sary.
r Rotate the tuning dial to se-
lect the desired tuning step.
t Push [V/MHz(SCAN)] to exit
set mode.
1 Push [VFO/LOCK] to select VFO mode, if
VFO/LOCK
necessary.
2 Push [
3 Push [
"TS" appears.
4 Push [Y] or [Z] to select the desired tuning
step.
5 Push [
or
SETTING A FREQUENCY
B] to enter set mode.
SET
B] or [ C] several times until
SET ENT
A] to exit set mode.
CLR
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
14