Connecting The Ups Cord Retention Clips; Charging The Ups Batteries - HP R3000 User Manual

CAUTION:
current drawn by this type of printer can overload the UPS.
Before connecting devices, verify that the UPS will not overload by checking that the ratings of the devices
do not exceed the UPS capacity. If the equipment rating is listed in amps, multiply the number of amps by
the selected output voltage to determine the VA.
After verifying that the UPS will not overload (depending on your model):
•
Connect the device power cords to the output receptacles on the rear panel of the UPS.
-or-
•
Connect devices to the output receptacles on the rear panel of the UPS using the IEC-to-IEC power
cords included with the UPS.
To provide additional receptacles:
•
Plug a PDU into the PDU output receptacle. The PDU output receptacle is part of load segment 1 and
can be turned off and on using power management software (on page 51).
•
Plug an extension bar into any IEC-320-C19 receptacle to yield eight additional IEC-320-C13
receptacles.

Connecting the UPS cord retention clips

NOTE:

Charging the UPS batteries

With the UPS in Standby mode, allow the batteries to charge before putting the UPS into service.
Do not plug laser printers into the UPS output receptacles. The instantaneous
UPS appearance might vary depending on the specific unit installed.
Installation 25