Removing A Processor - HP Integrity rx1620 Maintenance Manual

Figure 29 Processor Location
WARNING!
disconnected from the server prior to removing or replacing a processor.
Voltages are present at various locations within the server whenever an AC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning could result in personal injury or damage to equipment.
CAUTION:
behavior or system failure. For assistance with this procedure, contact your local HP Authorized
Service Provider.
Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety
precautions could result in damage to the server.
Avoid contact with the processor heatsink if the server has been operating prior to the installation
of the additional processor. The heatsink will be safe to touch after the cover has been removed
for a few seconds.

Removing a Processor

To remove a processor, perform the following steps:
1. Turn off the system and disconnect all cables.
2. Remove the cover. See
3. Remove the sheet metal air duct.
4. Disconnect the power pod cable from the power connector on the system board.
34 Removing and Replacing Components
Ensure that the system is powered-down and all power sources have been
Failure to properly complete the steps in this procedure will result in erratic system
"Removing and Replacing the Cover" (page 30).