Quick Start Guide - Quadra-Fire MTVERNON-AE-MBK Owner's Manual & Installation

Mt. Vernon Pellet Stove (AE)
H. Quick Start Guide
Any button pressed will turn on the backlight. Wall control will automati-
NOTICE:
cally revert back to the starting screen if there is no activity for 15 seconds; except
for the "CONFIRM FUEL CHANGE" screen.
CHOOSING FUEL TYPE
R A
Set at
MENU
1. At the starting screen, press "MENU"
button once or twice until "MENU"
screen appears.
MENU
Set Comfort Level
A to/ an al/ ff
Fuel Type
ser Settings
2. Highlight "FUEL TYPE" using the "UP/
DOWN" buttons to the right side of the
display. Press "SELECT".
F L S L C
Soft ood Pellet
S nflo er Seeds
heat
ard ood Pellet
3. Scroll down and highlight "HARD-
WOOD PELLET" or your fuel type.
4. Now press "SELECT" to choose new
fuel
C F R F L C A
Please empt hopper
of old f el t pe and
ens re fire o is lean
Please refer to
se tion in man al
DONE
5. Press "DONE" to
change.
6. Press "DONE" twice or wait 15 sec-
onds for starting screen to reap-
pear.
7. Fill the hopper with fuel, and if the
hopper was completely empty, or has
run out of fuel, throw approximately
1/2 cup of pellets into the firepot.
8. Be sure the hopper lid and glass
door are both closed.
Page 26
P
Room
Temp
Wall Control for Reference
TURNING ON APPLIANCE
R A
1. At the starting screen, press "MENU".
2. Highlight "AUTO/MANUAL/OFF".
Press "SELECT".
A
3. Highlight "MANUAL". Press "SELECT
4. Press "DONE" twice or wait 15 seconds
confirm fuel
for starting screen to reappear.
ttons
Up
R A P
Set at
Down
MENU
HEAT OUTPUT
Function Buttons
P
Set at
MENU
Set Comfort Level
A to/ an al/ ff
F el pe
ser Settings
/ A AL S S
A tomati
an al
an al
ff
".
7034-106E
CHOOSING TEMP UNIT:
°F or °C
R A
Set at
MENU
1. At the starting screen, press "MENU"
button once or twice until "MENU"
screen appears.
Set Comfort Level
A to/ an al/ ff
F el pe
ser Settings
2. Highlight "USER SETTINGS" using the
"UP/DOWN" buttons to the right side of
the display. Press "SELECT".
S R S S
emp nits F/C
Flame eight Ad st
emp ifferential
2. Highlight "TEMP UNITS F/C" using the
"UP/DOWN" buttons to the right side of
the display. Press "SELECT".
3. Press the "UP" or "DOWN" button
to set desired temperature unit and
press "SELECT"..
4. Press "DONE". Press "DONE" again,
or wait 15 seconds for starting screen
to reappear.
September 1, 2008
R
P