Firebrick Replacement - Quadra-Fire 21M-ACC Owner's Manual

2100 Millennium Wood Stove (ACC)
D. Firebrick Replacement
Replace the firebrick if they become crumbly and/or if
there is a 1/4 inch (6.35mm) gap between the bricks.
Inspect the firebrick after each ash removal.
The firebox is lined with high quality firebrick, which has
exceptional insulating properties. There is no need to
use a grate; simply build a fire on the firebox floor. Do
not operate appliance without firebrick.
1. After the coals have completely cooled, remove all
old brick and ash from unit and vacuum firebox.
2. Remove new brick set from box and lay out to
diagram shown.
3. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks.
Slide top of bricks under clip on back of firebox wall
and push bottom of brick back.
5. Install side bricks. Slide top of brick under clips
on side of firebox and push the bottom of the brick
until it is flush with the side of the unit.
Use Part 832-0550 when ordering individual brick. Provide brick
dimension or copy this page, mark the desired brick and take it
to your authorized dealer.
Page 30
1
1
1
2
5
8-1/2 inches (216mm)
8-1/2 inches (216mm)
Figure 30.1
No.
1 9 x 4-1/2 x 1-1/4
2 6 x 4-1/2
3 8 x 4-1/2 x 1-1/4
4 Brick with angle (see drawing)
5 Brick with angle (see drawing)
7039-131H
3
3
1 1 1
2
2
1-3/8 in.
(35mm)
4
1-3/4 in.
(44mm)
6-1/4 inches
(159mm)
7 inches (178mm)
5
Brick Size
R
1
1
1
4
3 inches
(76mm)
Qty
9
3
2
1
1
May 5, 2011