System Information - Foxconn 45CMV series User Manual

System Information

This submenu is used to set up the standard BIOS features, such as the date, time, IDE channel
and so on. Use the arrow up/down keys to select an item, then use the <+> or <-> keys to change
the setting.
Date (mm:dd:yy)
Time (hh:mm:ss)
► IDE Channel 0 Master
► IDE Channel 0 Slave
x IDE Channel 1 Master
x IDE Channel 1 Slave
► IDE Channel 2 Master
► IDE Channel 2 Slave
Halt On
Model Name
BIOS ID
BIOS Version
CPU Name
Memory
MAC Address
↑↓→←:Move Enter:Select
► Date - <weekday><month><date> <year> format
Day—weekday from Sun. to Sat., automatically displayed by BIOS (Read Only).
Month—month from 1 to 12.
Date—date from 1st to 31st.
Year—year, set up by users.
Use <Enter>, <Tab> keys to select a field. Use <+>, <->, <PageUp> or <PageDown> to select
a value.
► Time - <hour> : <minute> : <second> format
This item allows you to configure the desired time. Use <Enter>, <Tab> to move forward and
select a field. Directly input a value or use <PageUp>, <PageDown>, <+> or <-> to select a
value.
► IDE Channel 0/1/2 Master/Slave
These categories identify the hard disks connected to the PATA and SATA ports in the system.
The display of each channel will be different if the setting of SATA Controller (in OnChip IDE
Device menu) is set to [Combined Mode], [Enhanced Mode] or [SATA Only] mode.
In each channel's display, you can press [Enter] to go to its submenu. You can further config-
ure specific drive settings. [None] and [Auto] settings allow you to enable or disable this drive.
[None] means no HDD is installed or set, and [Auto] means the system can auto-detect the
hard disk when booting up. In Access Mode setting, selections of [CHS], [LBA], [Lage] and
[Auto] can help you to select hard drive for legacy compatibility.
Phoenix - AwardBIOS CMOS Setup Utility
System Information
Sat, Nov 24 2007
11 : 59 : 49
[ Maxtor 6Y080L0
[None]
None
None
[ None]
[ None]
[All , But Keyboard]
45CMV-K/45CMV
945M10-GA.F1.B.07
792F1B07
Genuine Intel[R] CPU
1024MB
00-01-6C-20-FC-F1
+/-/PU/PD:Value F10:Save
F5: Previous Values F7: Optimized Defaults
22
Item Help
Menu Level ►
] Press [Enter] to enter
next page for detailed
hard drive settings
ESC:Exit F1:General Help