Foxconn 45CMV series User Manual page 45

► OnBoard Serial Port 1
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► OnBoard IrDA Port
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard IrDA
port.
► IrDA Mode Select
This item is used to configure IrDA port as :
[IrDA] : an IrDA device for maximum 115200 bit/s.
[ASKIR] : A faster IrDA for 1152000 bit/s.
► IrDA Duplex Mode
This item enables you to determine the infrared function of the onboard infrared chip.
USb Devices Setting
USB 1.1 Controller
USB 2.0 Controller
USB Operation Mode
USB Keyboard Function
USB Mouse Function
USB Storage Function
*** USB Mass Storage Device Boot Setting ***
↑↓→←:Move Enter:Select
► USB 1.1 Controller
This item is used to enable or disable the Universal Host Controller Interface for USB.
► USB 2.0 Controller
This item is used to enable or disable the Enhanced Host Controller Interface for USB.
► USB Operation Mode
This item is used to set the USB operation mode. If you select the [High Speed], then the USB
operation mode is determined by the USB device; select [Full/Low Speed], the USB device
operates on full/low speed.
► USB Keyboard Function
This item is used to enable the support for USB keyboard on legacy OS. If you have a USB
keyboard, set to auto or enabled.
► USB Mouse Function
This item is used to enable the support for USB mouse on legacy OS. If you have a USB
mouse, set to auto or enabled.
Phoenix - AwardBIOS CMOS Setup Utility
USB Devices Setting
[Enabled]
Enabled
[Enabled]
[High Speed]
[Enabled]
[Enabled]
[Enabled]
+/-/PU/PD:Value F10:Save
F5: Previous Values F7: Optimized Defaults
38
Item Help
Menu Level ►
[Enable] / [Disable]
Universal Host
Controller
Interface for Universal
Serial Bus
ESC:Exit F1:General Help