Integrated Peripherals - Foxconn 45CMV series User Manual

Integrated Peripherals

► OnChip IDE Devices
► OnBoard Devices
► SuperIO Devices
► USB Devices Setting
↑↓→←:Move Enter:Select
► OnChip IDE Devices / OnBoard Devices / SuperIO Devices / USB Devices Setting
Press <Enter> to go to relative submenu.
onChip IDe Devices
IDE HDD Block Mode
IDE DMA Transfer Access
On-Chip Primary PCI IDE
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
On-Chip Secondary PCI IDE
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
*** On-Chip Serial ATA Setting ***
SATA Controller
SATA Port Speed Settings
x PATA IDE Mode
SATA Port
↑↓→←:Move Enter:Select
► IDE HDD Block Mode
If your IDE hard drive supports block mode, select [Enabled] for automatic detection of the
optimal number of block read/write per sector.
► IDE DMA Transfer Access
[Disabled] : to disable DMA transfers for all IDE drives. They will revert to PIO mode transfers.
[Enabled] : to enable DMA transfers for all IDE drives. The proper DMA mode will be detected
at boot-up. If the drive does not support DMA transfers, then it will use PIO mode instead.
Recommend leaving this BIOS feature at the default [Enabled] setting. You should only disable
Phoenix - AwardBIOS CMOS Setup Utility
Integrated Peripherals
[Press Enter] Press Enter
[Press Enter]
[Press Enter]
[Press Enter]
+/-/PU/PD:Value F10:Save
F5: Previous Values
Phoenix - AwardBIOS CMOS Setup Utility
OnChip IDE Devices
[Enabled] Enabled
[Enabled]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
[Enhanced Mode]
[Force GEN II]
Primary
P1,P3 is Secondary
+/-/PU/PD:Value F10:Save
F5: Previous Values F7: Optimized Defaults
35
Item Help
Menu Level ►
ESC:Exit F1:General Help
F7: Optimized Defaults
Item Help
Menu Level ►
If your IDE hard drive
supports block mode
select Enabled for
automatic detection of
the optimal number of
block read/writes per
sector the drive can
support.
ESC:Exit F1:General Help