Toshiba 24V4210U User Manual page 277

Usingthe TV's features _
Adjusting the audio
3 Press the (A/Y arrow) buttons to highlight the Audyssey
ABX
TM
field.
4 Press the (_/_ arrow) buttons to select On.
Using Audyssey D ynamic Volume ®
This feature provides a consistent sound volume between television
programs, commercials, and between the loud and soft passages of
movies.
1 Press the MENU button. Select Settings, SOUND, Audyssey
Premium Television, Dynamic Volume.
2 Press the (_/_ arrow) buttons to select ON or Off.
NOTE .:. If Dynamic RangeControl is set to On, this feature is
automatically set to Off.
•:. This featuredoes not affectthe audio signal output from the
DIGITALAUDIOOUTterminal.
Selecting t heoptical a udiooutput format
You can select the optical audio output format when you connect a
Dolby _>Digital decoder or other digital audio systems to the TV's
Digital Audio Out terminal.
To select the optical audio output format:
1 Press the MENU button to open the Sound menu.
2 Highlight Audio Setup, and then press the OK button.
3 In the Digital Output Format field, select either Dolby
Digital or PCM, depending on your device.
4 To save the new settings, highlight Done, and then press the
OK button.
5 To reset the settings to the factory defaults, highlight Reset,
and then press the OK button.
Usingthe Dolby _ DigitalDynamicRangeControlfeature
You can further compress Dolby ® Digital dynamic range, allowing
you to switch from digital to analog broadcasts at the same dynamic
range.
To use the Dolby ® Digital Dynamic Range Control:
1 Press the MENU button to open the Sound menu.