Toshiba 24V4210U User Manual page 210

1 08 Using theTV'sfeatures
No Signal Power Down
NoSignalPowerDown
The TV will automatically turn itself oft"after 15 minutes when no
signal is detected.
olo You can change the setting to Oft"for the following functions:
o}o Low signal strength of an analog channel (no signal detection)
*}o Only Audio L/R is connected to external input to listen to
music through the TV speakers.
1 From the Preferences menu, highlight Energy Saving
Settings, and then press the OK button.
2 Press the (A/Y arrow) buttons to select No Signal Power
Down, and then press the OK button.
3 Press the (A/Y arrow) buttons to highlight the item you wish
to change, and then press the (41_ arrow) buttons to select
On/Off.
NOTE o:o Default s ettingfor eachinputis On,
¢ A warningmessage a ppears approximately I minutebeforethe
TVturnsOff.
Using HDIVII@ CEC
This is a new feature that uses CEC technology and allows you to
control Toshiba HDMI® CEC compatible devices from the TV
remote control via an HDMI + connection.
When the Enable HDMI® CEC in the HDMI® CEC Setup menu is
set to On, the following HDMI® CEC functions are enabled.
HDIVII® CEC playbackdevice (DVDplayer,etc.)control
With your TV's remote control, or using the HDMI® CEC Player
Control menu, you can control the connected HDMI® CEC
playback device you are watching.
Available remote control key functions:
Button. Description."
PLAY Begin playback
STOP Stopplayback
PAUSE Pause t hepicture duringplayor record mode
SKIP Forward SkipForward