Standing Pilot Ignition; For Your Safety; To Turn Off - Heat & Glo SL-550TV-D Owner's Manual

Standing Pilot Ignition

FOR YOUR SAFETY

READ BEFORE LIGHTING
WARNING:
exactly, a fi re or explosion may result causing property
damage, personal injury or loss of life.
A. This appliance has a pilot which
must be lighted by hand. When light-
ing the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING, smell all
around the appliance area for gas.
Be sure to smell next to the fl oor
because some gas is heavier than
air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
WARNING:
DO NOT CONNECT 110 VAC TO
THE CONTROL VALVE.
Improper installation, adjustment, al-
teration, service or maintenance can
cause injury or property damage. Refer
to the owner's information manual pro-
vided with this appliance.
This appliance needs fresh air for
safe operation and must be installed
so there are provisions for adequate
combustion and ventilation air.
If not installed, operated, and main-
tained in accordance with the manufac-
turer's instructions, this product could
expose you to substances in fuel or
fuel combustion which are known to the
State of California to cause cancer, birth
defects, or other reproductive harm.
Keep burner and control compartment
clean. See installation and operating
instructions accompanying appliance.
For additional information on operating your
Hearth & Home Technologies fi replace, please refer to www.fi replaces.com.
If you do not follow these instructions
• If you cannot reach your gas sup-
plier, call the fi re department.
C. Use only your hand to push in or
turn the gas control knob. Never use
tools. If the knob will not push in or
turn by hand, don't try to repair it, call
a qualifi ed service technician. Force
or attempted repair may result in a
fi re or explosion.
D. Do not use this appliance if any part
has been under water. Immediately
call a qualifi ed service technician to
inspect the appliance and to replace
any part of the control system and
any gas control which has been
under water.
CAUTION:
Hot while in operation. Do not touch.
Keep children, clothing, furniture, gaso-
line and other liquids having fl ammable
vapors away.
Do not operate the appliance with
panel(s) removed, cracked or broken.
Replacement of the panel(s) should be
done by a licensed or qualifi ed service
person.
NOT FOR USE
WITH SOLID FUEL
For use with natural gas and propane.
A conversion kit, as supplied by the
manufacturer, shall be used to convert
this appliance to the alternate fuel.
Also Certifi ed for Installation in a
Bedroom or a Bedsitting Room.
For assistance or additional informa-
tion, consult a qualifi ed installer, service
agency or the gas supplier.
Heat & Glo • SL-550 / 750 / 950TV-D • 2053-985 Rev. J • 4/07
LIGHTING
INSTRUCTIONS
1. Turn off all electric power to the appliance.
2. Push in gas control knob
slightly and turn clockwise
to "OFF".
NOTE: Knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
3. Wait fi ve (5) minutes to clear out any gas. Then
smell for gas, including near the fl oor. If you smell
gas, STOP! Follow "B" in the Safety Information
located on the left side of this label. If you don't
smell gas, go to next step.
4. Find the pilot. The pilot is inside
combustion chamber next to the
main burner.
5. Turn knob on gas control counter clockwise
to "PILOT".
6. Push in control knob all the way and hold in. Im-
mediately depress red or black piezo button. It may
require several depressions of the red or black
piezo button until PILOT lights. If PILOT light does
not light after 10 seconds, return to step 3. Continue to
hold the control knob in for about one minute after the
pilot is lit. Release knob and it will pop back out. Pilot
should remain lit. If it goes out, repeat steps 3 through 6.
• If knob does not pop up when released, stop and im-
mediately call your service technician or gas supplier.
• If the pilot will not stay lit after several tries, turn
the gas control knob to "OFF" and call your service
technician or gas supplier.
7. Turn gas control knob counterclockwise to
"ON".
8. To light Burner, fl ip the on/off switch to the "ON" posi-
tion, and close access grille.
9. Turn on all electric power to the appliance.

TO TURN OFF

GAS TO APPLIANCE
1. Turn off all electric power to the appliance if service
is to be performed.
2. Open control access panel.
3. Move switch to "OFF" position.
4. Push in gas control knob slightly and turn clock-
wise to OFF". Do not force.
5. Close control access panel.
464-903G
33