Installing The Fireplace; Step 1. Locating The Fireplace - Heat & Glo Pier-HV-IPI Owner's Manual

3

Installing the Fireplace

Step 1. Locating the Fireplace

The diagram below shows space and clearance require-
ments for locating a fireplace within a room.
Note: Refer to Figure 4B for dimensions and appliance
locations if installing a Pier-HV unit with a Catalina shelf
and/or marble package.
GLASS
PIER-HV-IPI
TOP VIEW
36"
GLASS
GLASS
ST-HV-IPI
TOP VIEW
GLASS
36"
Figure 4A. Fireplace Dimensions and Locations
Note: Refer to the Catalina installation instruction
included with kit for assembly and installation.
GLASS
RCOR-HV-IPI
GLASS
TOP VIEW
GLASS
36"
36"
36"
36"
GLASS
LCOR-HV-IPI
36"
TOP VIEW
GLASS
Heat & Glo • PIER-HV-IPI, ST-HV-IPI, L&R-COR-HV-IPI • 2005-900 Rev. K • 11/06
Note: This location diagram MUST be followed when in-
stalling a Pier-HV with a Catalina shelf/marble package
since the fireplace is installed further from finished wall.
45 -1/4 in.
(1149mm)
50-1/2 in.
47-1/2 in.
Marble sizes (inches):
Header .................................. 26 x 8
Side headers .................. 45-1/2 x 8
Legs ................................ 33-1/2 x 7
Fireplace Locations/Dimensions with
Figure 4B.
Catalina Shelf/Marble Package ONLY
Clearance Requirements
The top, back, and sides of the fireplace are defined by
stand-offs. The minimum clearance to a perpendicular wall
extending past the face of the fireplace is one inch (25 mm).
The metal ends of the fireplace may NOT be recessed into
combustible construction.
FINISHED
WALL
34-1/2 in.
7 in.
13/16 in.
45-1/4 in.
19