Troubleshooting; Error & Status Messages On The Display Panel - Ricoh LD225 Function Manual

Troubleshooting

Error & Status Messages on the Display Panel
This section describes the principal messages that appear on the panel display.
If a message not described here appears, act according to the message.
Reference
Before turning the main power off, see "Turning On the Power", General Set-
tings Guide.
❖ Status messages
Message
Hex Dump Mode
Offline
Please wait.
Printing...
Ready
Resetting job...
Setting change...
Waiting...
❖ Alert messages
Messages/Second messages
Authentication has failed.
Ethernet board has a prob-
lem.
HDD has a problem.
In the Hex Dump mode, the machine receives data in hexadec-
imal format. Turn off the machine after printing, and then turn
back on.
The machine is offline. To start printing, switch the machine
online by pressing [Online] on the display panel.
The machine is preparing the development unit. Wait a while.
The machine is printing. Wait a while.
This is the default ready message. The machine is ready for
use. No action is required.
The machine is resetting the print job. Wait until "Ready" ap-
pears on the display panel.
The machine is setting changing. Wait a while.
The machine is waiting for the next data to print. Wait a while.
Causes
The login user name or pass-
word entered is incorrect.
The machine currently cannot
perform authentication.
An error has occurred in the
Ethernet board.
An error has occurred in the
hard disk drive.
Troubleshooting
Status
Solutions
Check your login user name
and password.
Consult an administrator.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
8
149