Ricoh LD225 Function Manual page 162

Problem
When using Win- Make sure the application's paper size and orientation settings match those
dows 95 / 98 / Me of the printer driver.
/ 2000 / XP, Win-
If a different paper size and orientation are set, select the same size and ori-
dows Server 2003,
entation.
or Windows NT
4.0, combined
printing does not
come out as ex-
pected.
When using Win-
dows 95 / 98 / Me
/ 2000 / XP, Win-
dows Server 2003,
or Windows NT
4.0, Auto Re-
duce/Enlarge
print does not
come out as ex-
pected.
A print instruc- User Authentication may have been set. Consult the appropriate adminis-
tion was issued trators.
from the comput-
er, but printing
did not start.
The print job is not Even when the machine is offline, printing is performed when [Job Accep-
canceled even tance Priority] has been set in [Parallel Interface] in the [Interface Settings] in the
when the machine System Settings menu. Change the setting of Signal Control to Printer pri-
is switched to of- ority.
fline status.
See "User Tools (System Settings)", General Settings Guide.
Photo images are Some applications reduce print resolution.
coarse.
Fine dot pattern Make the following settings with the printer driver:
does not print.
• Change the [Dithering:] setting on the [Image Adjustments] tab in the
See the printer driver Help.
Images are cut off, You may be using paper smaller than the size selected in the application.
or excess is print- Use the same size paper as that selected in the application. If you cannot
ed. load paper of the correct size, use the reduction function to reduce the im-
age, and then print.
See the printer driver Help.
Causes and Solutions
[Change User Settings...] dialog box on the [Print Quality] tab in the RPCS
printer driver.
Note
❒ To enable [Change User Settings...], select the [User settings] check box.
Troubleshooting
8
155