Pentax K-X Operating Manual page 20
Hoya corporation
Hide thumbs
Also See for K-X:
- Operating manual (324 pages) ,
- User manual (40 pages) ,
- Manual de instrucciones (343 pages)
Table of Contents
Advertisement
iiiiiiiiiiiiiiii!
iiiiiili;_i?i_!i!:j_!!!
iiil;_!ii!i!i!ili
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iHHHHHHH
iHHHHHHH
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iHHHHHHH
iHHHHHHH
iHHHHHHH
• You can also change the setting from the [1_ Rec. Mode 4] menu (p.8O).
• The Shake Reduction function will not fully work (for about 2 seconds)
right
after turning on the camera or restoring from Auto Power Off. Wait for the
Shake Reduction function to become stable before gently pressing the shutter
release button to take a picture. Press the shutter release button halfway. The
camera is ready to take a picture when ((41ll)) appears
in the viewfinder.
- The Shake Reduction function is available with any IC-X
compatible PENTAX
lens. However. when the aperture ring is set to other than the A (Auto) position
or a lens without an A position is used. the camera will not operate unless [22.
Using Aperture Ring] is set to [Permitted] in the [C Custom Setting 4] menu. Set
this beforehand. However. in such cases some functions will be restricted. Refer
to "Notes on [22. Using Aperture Ring]" (p.284) for details.
The Shake Reduction
function
operates
by obtaining
the lens information
such as focal length.
If the camera
uses a DA, DA L, D FA, FA J, FA or F lens, the lens
information
is automatically
obtained
when the Shake Reduction
function
is activated.
The [Input Focal Length] setting screen appears when the camera
is
turned on with the Shake Reduction
function
set to ((4111)) and a type of lens
that does not support automatic
obtaining
the lens information
such as
focal length (p.282) is mounted.
Set the focal length manually
in the [Input Focal Length]
setting screen.
, The [InPut Focal Length] setting Screen does not appear when using a lens
that
supports automatic
obtaining
the lens information
such as focal length:
• When using a lens without the A position on the aperture or with the aperture
set to a position
other than the A position,
set [22. Using Aperture
Ring] in
the
[C Custom
Setting 4] menu to [Permitted].
(p.284)
1
Use the four-way controller
( 4 • ) or the e-dial to set the
focal length.
Selectfrom the following 34 focal length
values. (The default setting is 35 mm.)
Advertisement
Table of Contents
