7.
7
Identify and orient the Seat Handlebar (11) so
that the contacts on the Pulse Grips (10) face
upward. Make sure that the hexagonal
holes
are in the indicated
locations.
Tip: Avoid pinching the Pulse Wire (58).
Attach the Seat Handlebar (11) to the Seat
Carriage (3) with two M10 x 32mm Button Bolts
(78) and two M10 Locknuts (64). Do not fully
tighten the Locknuts
yet.
11
78
Hexagonal
Holes
10
Avoid pinching the
Pulse Wire (58)
.
Tip: Avoid pinching the Pulse Wire (58).
Attach the Backrest (8) to the Seat Carriage (3)
with two M6 x 18mm Patch Screws (77) and
two M6 x 42mm Patch Screws (51).
Tip: First tighten the M6 x 18mm Patch
Screws (77), and then tighten the M6 x
42mm Patch Screws (51).
See step 7. Tighten the M10 Locknuts (64).
8
51
77
9