Advertisement
ASSEMBLY
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver
(_====o
and an
adjustable wrench _:_.
As you assemble the exercise cycle, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-
assembled.
If a part is not in the hardware
kit, check to see if it has been preassembled.
M8 Locknut
(61)-4
M6 x 18mm Patch
Screw (77)-2
M8 x 16mm Patch
Screw (54)-6
M10 x 32mm
Button Bolt (78)-2
M10 Locknut
(64)-2
M6 Washer
(44)-4
M6 x 38mm Patch
Screw (81)-4
M8 x 38mm Button
Bolt (72)-4
M8 Split
Washer (55)-10
M4 x 16mm Flange
Screw (80)-4
M6 x 42mm Patch
Screw (51)-2
M10 x 63mm Bolt Set (62)-1
M8 x 55mm Patch
Screw (52)-4
5
Advertisement
