Table of Contents
Advertisement
•Hookups Without a Cable Box(cont'd)7
_ ,
;
•
Connect
the RF coaxial cable (supplied)
to the. RF OUT
Jack on the back of
theVCR
and to the ANTENNA
IN Jack on the TV. (You may use either a snap-on
type or screw-on type of coaxial cable,whichever you prefer. A snap-on type is supplied.)
Antenna
or Cable
RF coaxial cable
Antenna In Jack
(on back of TV)
example only
4
Plug in theTV
and theVCR.
5
Set the CH3/CH4
switch on the back of the VCR to CH3 or CH4, whichever
channel is not used or least used in your area.To operate yourVCR with your TV, set
the TV to the same channel. For example, when playing a tape, if the CH3/CH4
switch is set to CH3, the TV should be on channel 3.
CH3 / CH4
Switch
CH3
CH4
6
You are ready to turn on theVCR.
Please go to page 10 before turning
on the
VCR.
Advertisement
Table of Contents
