Fisher & Paykel OR60 Installation Instructions And User Manual page 43

Before using your cooktop
Before using your new cooktop, please:
Read this user guide, taking special note of the 'Safety and warnings' section.
Turn the power to the cooker on at the wall.
Make sure all controls are turned off.
Using the gas burners
1 Choose the control knob for the burner you want to use.
2 Press the knob down gently and turn it anticlockwise to the
the burners will spark.
3 Hold down the knob for approximately 10 seconds after the burner has lit. Releasing the
knob too soon will extinguish the flame.
4 Adjust the flame anywhere between the
between and
Note: if the burner does not light within 15 seconds, turn the control knob off and wait at
least one minute before trying again.
5 To turn the burner off, turn the knob clockwise to
After use, always turn the knobs to the
Flame failure safety feature
The flame failure probe cuts off the gas supply to the burner if the flame is blown out.
When lighting the burner on flame failure models, hold down the knob for approximately 10
seconds after the burner has lit. Releasing the knob too soon will extinguish the flame.
If the flames are accidentally extinguished, turn off the burner and do not try to light it again for
at least one minute (to allow the gas to disperse).
0
(OFF).
Using your gas cooktop
and positions. Do not adjust the flame
0
(OFF) until you hear the safety click.
0
(OFF) position.
position. The ignitors on all
41