Fisher & Paykel OR60 Installation Instructions And User Manual page 10

Installation instructions
8
Fitting the anti-tilt bracket
(four-function models)
Important!
To restrain the appliance and prevent it tipping
accidentally, fit a bracket to its rear to fix it
securely to the wall. Make sure you also fit the
supplied lock pin to the anti-tiit bracket.
To fit the anti-tilt bracket:
After you have located where the cooker
1
is to be positioned, mark on the wall the
place where the two screws of the anti-tilt
bracket have to be fitted. Please follow the
indications given in Fig.5a.
Drill two 8 mm diameter holes in the wall
2
and insert the plastic plugs supplied.
Important!
Before drilling the holes, check that you will not
damage any pipes or electrical wires.
Loosely attach the anti-tilt bracket with the
3
two screws supplied.
Move the cooker to the wall and adjust the
4
height of the anti-tilt bracket so that it can
engage in the slot on the cooker's back, as
shown in Fig.5a.
Tighten the screws attaching the anti-tilt
5
bracket.
Push the cooker against the wall so that the
6
anti-tilt bracket is fully inserted in the slot
on the cooker's back.
Access the bracket and fit the lock pin;
7
Remove the drawer (Fig. 5b).
Fit the lock pin through the bracket,
as shown (Fig.5c).
Refit the drawer.
0
+ 15 + 15
1
Lock pin
2
Lock pin
correctly fi tted
Fig. 5c Fitting the lock pin through the bracket
6 0 0 m m
Fig. 5a Fitting the anti-tilt bracket
Fig. 5b Removing the drawer
Anti-tilt bracket
attached on the
rear wall
Slot on the
cooker's back
(C a v it y w id th
)
Cooker's
back