Fisher & Paykel OR60 Installation Instructions And User Manual page 31

Care and cleaning
29
Burner parts and trivets
You can remove and clean these parts with hot soapy water or non-abrasive detergents. Clean
spills regularly before they become burnt on. Do not wash these parts in a dishwasher.
After cleaning, check that the burners and their flame spreaders are dry before replacing
correctly.
It is very important to check that the burner flame spreader and the cap have been correctly
positioned. Failure to do so can cause serious problems.
Note: to avoid damage to the electronic ignition, do not try to light a burner without all burner
parts correctly in place.
Replacing the auxiliary and semi-rapid burners
Carefully replace the burner parts as per the following Figs.
Check that the ignitor is always clean to ensure trouble-free sparking. Clean it carefully with a
toothbrush and methylated spirits (see Fig.26).
Cap
Flame
spreader
Ignitor
Fig. 29 Correct line-up of the Fig. 30 Replacing the auxiliary and
auxiliary and semi-rapid burner parts semi-rapid burner caps