GE P2B930 Owner's Manual And Installation Instructions page 55

GEAppliances.com
Possible Causes What To Do
Oven not clean after Oven controls not properly set.
• See the Using the self-cleaning oven section.
a clean cycle Oven was heavily soiled. , Clean up heavy spillovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or
for a longer period of time.
"LOCKDOOR"flashes The self-clean cycle has been • Close the oven door.
in the display selected but the door is not closed.
LOCKEDDOOR light The oven door is locked , Touch the Clear/Off pad. Allow the oven to cool.
is on when you want because the temperature inside
to cook the oven has not dropped below
the locking temperature.
"F--and a number or
letter" flash in the
display
You have a function error code.
If the function code repeats.
, Touch the Clear/Off pad. Allow the oven to cool for
one hour. Put the oven back into operation.
, Disconnect all power to the range for 5 minutes and
then reconnect power. If the function error code
repeats, call for service.
"Probe" appears in This is reminding you to enter , Enter a probe temperature.
the display a probe temperature after
plugging in the probe.
Display goes blank
A fuse in
your home may be
blown or the circuit breaker
tripped.
The clock is in the , See the Specialfeatures ofyour oven control section.
black-out mode.
Display flashes
Power failure. , Resetthe clock.
Unable to get the Oven control pads were , The Bake and Broil Hi/Lo pads must be touched at
display to show "SF" not pressed properly, the same time and held for 3 seconds.
Power outage, Power outage or surge. , Reset the clock. Ifthe oven was in use, you must reset
clock flashes it by touching the Clear/Off pad, setting the clock
and resetting any cooking function.
"B • _1 t, • sl urnmg or ally This is normal in a new oven , To speed the process, set a self-clean cycle for a
odor emitting from and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
the vent oven section.
Strong odor An odor from the insulation , This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Replacethe fuse or reset the circuit breaker.
LOCappears in display The Gas/Control Lockout feature
is activated
, Be sure the surface burner controls are turned OFF.
Turn this feature off to use the range. See the
Gas/Control Lockout section.
55