GE P2B930 Owner's Manual And Installation Instructions page 42

Installation Instructions
LOCATION
Do not locate the range where it may be subject to strong drafts. Any openings in the floor or walJ behind the range
should be sealed. Hake sure the openings around the base of the range that supply fresh air
for combustion and ventilation are not obstructed
by carpeting or woodwork.
Your range, like many other household items, is
heavy and can settle into soft floor coverings such as cushioned vinyl or carpeting. Use care when moving
the range on this type of flooring. It is recommended that the following simple and inexpensive instructions be followed to
protect your floor.
The range should be installed on a sheet of plywood
(or similar material). When the floor covering ends at the front of the range, the area that the range will rest on should be
built up with plywood to the same level or higher than the floor covering.
This will allow the range to be moved for cleaning
or servicing. Also, make sure your floor covering will withstand 180°F. (Seethe Installation Safety Instructions section.)
Make sure the wall coverings around your range can withstand the heat generated (up to 200°F) by the range. (Seethe
Installation Safety Instructions section.)
IMPORTANT!
Remove all tape and packaging. Make sure the burners are properly seated and level.
Take the accessory pack out of the oven and/or drawer.
Check to be sure that no range parts have come loose during shipping.
CONVERTING TO LP GAS (or converting back to natural gas from LP}
This range leaves the factory set for use with natural gas. If you want to convert to LP gas, the conversion must be
performed by a qualified LP gas installer.
The conversion instructions can be found on back of the range or attached to the range next to the pressure regulator.
Keep these instructions and the orifices in case you want to convert back to natural gas.
The conversion instructions identify where to find the kits on the model. The possible locations are defined in the picture
below.
Single Oven
Thumb screws
Remove Access Panels
(some models)
Bracket-LP Orifice Spud Box- LP Orifice Spud
(some models) (some models)
Double Oven
RearofRange
Orifice Box Location
(some models)
42