Shelves - GE Appliances Profile JGB902 Owner's Manual & Installation Instructions

Care and cleaning of the range. ......
Oven Shelves
If your oven is equipped with nickel oven
shelves, they should be removed fi'om the
oven before beginning the serf-clean cycle
Io clean the nickel shelves, use an abrasive
cleanser, After cleaning, rinse the sheh,es
with clean water and dry with a clean cloth,
If the sheh,es ever become hard to slide,
wipe the shelf edges or oven shelf supports
with vegetable oil
If your oven is equipped with gray porcelain-
coated sheh,es, they may he deaned in the
oven during t!_e self-clean cycle
_tley may also be cleaned by using an
abrasive deanser, After' cleaning, rinse the
shelves with clean water and dry _dth a
clean cloth, If the shelves ever"become hard
to slide, wipe the shelf edges or oven shelf
suppom with vegetable oil.,
Wire cover holder.
Oven Light Replacement
CAUTION: Before replacing yourovenlightbu&
disconnect theelectrical powerto therange at the
mainfuseor circuitbreaker panel Besuretolet the
lightcover andbulbcoolcomplete&.
rhe oven light bulb is covered with a
removable glass cover that is held in place
with a bail-shaped wire, Remove the oven
door, if desired, to reach cover' easily,
Toremove:
Hold a hand under the cover so it
doesn't fall when released.
With
fingers of the same hand, firmly push
back the _dre cover holder: Lift off
tire cove[:
Do not remove any screws to remove
the cover,
[_] Do not touch hot bulb with a wet
cloth, Replace bulb with a 40-x_tt
household appliance bulb_
Toreplace cover.
%
Place it into the groove of the light
receptacle Pull the wire forwaa'd to the
center oI tim cover until it snaps into
place. When in place, the wire holds
the cover firmly Be certain tim wire
is in the depression in the center of
the covet_
Connect electrical power to the range.
4O