GE Appliances Profile JGB902 Owner's Manual & Installation Instructions page 54

Before YouCall For Service...
IIIIIIIIIIIIIIIIIIIIIIIIl!llqll!llllllllllllll!lll I J
Troubleshooting Tips
Possible Causes What To Do
Oven light does not work Light bulb is loose or defective, • Tighten or' replace the bulb,,
Plug on range is not completely • Make sure electrical plug is plugged into a live, properly
inserted in the electrical oudet, grounded oudet.
Oven willnot self*clean The oven temperature is too • Allow the range to coot to room temperature and
high to set a serf-dean operation, reset fire controls,
Oven controls kmpmperty set. • See the Using the self-cleaning oven section,
"Crackling" or 'Ibis is the sound of the t This is normal
"popping"sound metal heating and cooling
dmlng
both the
cooldng
and
cleaning
functions.
Excessive smoking Excessive soil. • Touch the CLEAR/OFFpad, Open the windows to
rid the room of smoke_ Wait undl the LOCKEDDOOR
light goes off Wipe up the excess soil and reset the
clean cycle_
Oven door will not open
Oven too hot.
• Allow the oven to cool below locking
temperature.
after a clean cycle
Ovennot clean after a
Oven controls not properly set
• See the Using theself-cfeaning oven section
clean cycle Oven was heavily soiled. • Clean up heavy spillovers before starting the cIean
cycle_ Heavily soiled ovens may need to self<lean
again or [bra longer period of dme
"LOCK OOOR"flashes The self-clean cycle has been * Close the oven door.
in the display selected but the door is not
closed.
LOCKEDDOOR light The oven door" is locked = 'Touch the CLEAR/OFF pad, Allow the oven to cool.
is on when you want because the temperatuxe
to cook inside the oven has not
dropped below the
locking temperature.
"F--and a number or
You have a function error' code. ° Touch
the CLEAR/OFF pad, Allow the oven to cool for
letter" flash in the display
one hour, Put the oven back into operation.
If the function code repeats. * Disconnect all power to the range for5 minutes
and then reconnect power: I[ the function error
code repeats, call fbr service,
Oven shelves are The nickel shelves (if so equipped) • Apply a smalI amount of vegetable oil to a paper
difficult to slide were cleaned in a serf-dean cycle, towel and wipe the edges of the oven shelves with
The gray porcelaln-coated shelves fl_e paper towel Do not spray with Pare _ or" other
(if so equipped) were improperly lubricant sprays,
cleaned.
"Probe"appears in This ksreminding you to enter a o Enter a probe temperature.
the display (some models) probe temperature after' plugging
in the probe,
54