GE Appliances Profile JGB902 Owner's Manual & Installation Instructions page 44

Installation Instructions
iiiiiiiiiii ii1,, ,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,, ,, ,,, ,, ,
A WARNING!
ANTI-TIP DEVICE
All ranges can tip and injury could
result.
To prevent accidental tipping of the range,
attach an approved Anti-Tip device to the
wall. (See Installing the Anti-tip Device in
this section.) To check if the device is
installed and engaged properly, cax'efully
tip the range forward. The Anti-Tip device
should engage and prevent the range from
tipping over_
If you pull the range out from the wall for
any reason, make sure the AntbTip device
is engaged when you push the range back
against the wall.
Ill For" your s,_my, never use your range for warming
or' heating the room. "Your oven and cooktop are
not designed to heat your kitchen, 'Iop but'nets
should not be operated without cookware on the
grate, Such abuse could result in fire and damage
to your range and will void your warranty.
[] Do not store or use combustible materials,
gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance
Explosions or fires could result.
[] Do not use oven for a storage area_ Items stored in
the oven can ignite,
[] Do not let cooking grease or other flammable
materials accumulate in or near the range°
LOCATION
Do not Iocate the range where it may be subject to
strong ds'afts, Any openings in the floor or wall behind
the range should be sealed. Make sure the openings
around the base of the range that supply fresh aLr for
combustion and ventilation are not obstructed by
carpeting or woodwork.
Your range, like many other household items, is
hea W and can setde into soft floor coverings such as
cushioned "dnyl or carpeting, Use care when moving
the range on dais type of flooring. It is recommended
that the fbllowing simple and inexpensive instructions
be followed to protect your floor
1?he range should be installed on a sheet of"plDvood
(or similar material) v_qmn the floor cm,ering ends at
the front of the range, the area that the range will rest
on should be built up with plywood to the same level
or higher than the floor covering,
Ihis will allow the range to be moved for cleaning
or servicing, Also, make sure your" floor covering will
withstand 180°E
(See the Installation Safety instructions
section)
Make sure the wall coverings around your range can
withstand the heat generated (up to 200°F) by the
range (See the Installation Safety Instructions secdon,)
IMPORTANT!
Remove al! tape and packaging_ Make sure the
burghers are properly seated and level.
Take the accessory pack out of the oven and/or
d/awer_
Check to be sm'e that no range parts have come loose
during shipping.
44