GE Appliances Profile JGB902 Owner's Manual & Installation Instructions page 33

Burner Caps and Heads
NOTE: Before removing the burner caps
and heads, remember their size and location
Replace them in the same location after
cleaning The top sides of the Right Front:
Right Rearand Left Front burner heads are
marked with the letters "RF, " 'RR" and "LF,"
respectivetg to aid reassemblg
Burner caps
Lift off when cool, Wash burner" caps
in hot, soapy water and rinse with clean
watel: You may scour with a plastic
scouring pad to remove burned-on
food particles,
Burner heads
The slits in the burner heads of your
cooktop must be kept clean at all times,
Clogged or dirt), burner ports or
elecu'odes will not allow the burner to
operate properly,
Any spill on or around an elecu'ode must
be carefully cleaned, Take care to not hit
an electrode with anything hard or it
could be damaged
You should clean the burner caps,
burner heads and burner bases routinely,
especially after bad spillovers, which
could clog the openings in the burner
heads,, Lift off when cooI_
To remove burned-on fbod, soak the
burner beads in a solution of mild liquid
detergent and hot water for 20-30
minutes, For more stubborn stains,
use a toothbrush
After cleaning
Befbre putting d_e burner caps and
heads back, shake out excess water and
then dry them tlaoroughly by setting in a
warm oven for 30 minutes,
NOTE: D onotusesteelwoolor scouring p owders
tocleantheburners or electrodes This candamage
theburners andelectrically s horttheelectrodes
wwvv,GEAppliances, c om
Replacement
The top sides of' the Right Front, Right
Rear and LeI;c Front burner heads are
mmked with the letters "Pd7,, '' "RR" and
"LE" respectively, to aid reassembly
Medium h_ad
(not m ad<edl
aadcap
Largo h ead
andcop
Smallhead
andcap
Front o frange
€
Extra large
head and
cap
Replace the burner heads on the bases
matching
d_e letters,
Replace the caps on
the heads, Make sure that the caps and
heads are replaced in die correct
location, There is one small, one
medium, one large and one extra large
head and cap
When replacing, make sere the locater pins in the
burner head are seated in the pin slots of the burner
base Rotatethe burner head aroundthe burner base
until ff is level and securely seated
33