Operating Learn Function - Marantz SR7005 User Manual

Operating components
n Set top box for satellite (SAT) operation
Operation buttons
SOURCE ON/OFF
CHANNEL +, – Switch channels (up/down)
uio p
ENTER
0 – 9
CLR Clear the inputting
TV power on/standby
TV POWER
(Default : Marantz)
TV INPUT
(Default : Marantz)
SVENSKA NEDERLANDS

Operating learn function

• If the AV device is not a Marantz device, or if the device does not
operate even when the preset code is registered, use the learning
Function
function. Remote codes for different devices can be remembered
Power on/standby
for use by the Marantz remote control included with this device.
• This remote control unit is capable of learning around 160 codes.
Cursor operation
Enter
Remembering remote control codes from
Channel selection
other devices
1
Place the Marantz remote control and remote control
Switch TV input
from the other device approximately 5 cm apart,
with the remote control signal transmission sections
facing each other.
2
Press and hold down
SOURCE SEL
indicator blinks.
3
Press input source select buttons
to select the input source.
The input source is shown in the remote
control display.
4
Select the button to be learned.
LEARN indicator lights up.
ESPAÑOL ITALIANO
5 cm
SET and
until the LEARN
FRANÇAIS DEUTSCH
5
Press and hold the button that you want to register
on the other remote control until "OK" is displayed
on the Marantz remote control display.
• If "NG" is shown on the remote control display, perform step 5
again. If "NG" is shown again on the remote control display, the
remote control may not be able to learn the code correctly. In this
case, use the specialized remote control for the device.
• If the remote control memory becomes full, "FULL" is shown
on the remote control display. If you want to learn the code, you
should erase other learned button.
6
Repeat steps 4 and 5 to learn other buttons for the
same input source.
7
Repeat steps 3 to 6 to learn other input sources.
8
When programming of the remote control unit is
completed, press SET .
The LEARN display disappears, and the remote control unit
exits learn mode.
NOTE
SOURCE ON/OFF
• The learning function is unavailable for all
HDMI
and in any mode.
• The learning function is unavailable for all buttons in TUNER mode,
AMP mode, NET/USB mode and M-XP mode.
• The learning procedure does not operate correctly if the batteries
have become worn.
• If no buttons are pressed for approximately 1 minutes while in the
LEARN mode, the remote control unit automatically exits from the
LEARN mode.
ENGLISH
MACRO
,
89