Table of Contents
Advertisement
Push Block
Use a
3/4"
piece of plywood.
h
1 2 '
W
I C
Handle should be in center of plywood piece. Fasten with glue and wood screws as shown.
Small piece
(3/8"
x
5/16"
x
2") of wood must always be glued to plywood
t o keep saw
blade from dulling if operator cuts into push block by mistake. (Never use nails in push
block
.
)
Auxiliary Fence
Make auxiliary fence from
3/8"
and
3/4"
plywood pieces.
1-1
/2"
Faceledge
parallel
Fasten with glue and wood screw.
Wood Facing (Rip Fence)
A wood facing should be used for opera-
tions when blade comes close
to
fence.
Wood facing for rip fence should be same
size as fence.
Make sure bottom of facing is flush with
table surface.
12
Hide quick links:
Advertisement
Table of Contents
