Adjusting For Zero Setting; Key Safety Switch - Makita 2708 Instruction Manual

Bring the ruler underplate flush up against
the rail inside, then fasten the hex bolt
attaching the underplate very securely.
ADJUSTING FOR ZERO SETTING
Bring the rip fence up flush against the side
of the blade and loosen the screw. Then
align the arrow with the zero indication on
the table scale before tightening the screw.
KEY SAFETY SWITCH
Press the ON pushbotton switch to put the
table saw on; press the OFF button to put
it
off.
This machine can only be switched on after
the key i s pressed in the switch. When not
in use, take off the key and the machine
should be both "OFF" and unplugged.
The key can be removed with the switch
in the "ON" condition, and the tool may
be switched off without the key.
I
Hex bolt -attaching
d
under d a t e
\
Ruler under date
I
WARNING:
Be sure that the blade is not contacting the wood before switching on.
When switching off, do not attempt to stop the blade by pressing on the side of the blade
with some object.
10