Using The Delta 1010 With Your Music Software Application - M-Audio Delta 1010 Manual

Using the Delta 1010 with your Music
Software Application
Once the Delta 1010's hardware and driver software are properly installed, it is
ready for use with your music application software. Some of these applications
may require you to highlight or enable the Delta 1010 drivers within the
program, and others may have a utility that analyzes or profiles the audio cards
in your system and enables the drivers. Your software should have an audio
device driver setup page, as well as a MIDI driver setup page.
WINDOWS MME AUDIO INPUT DEVICES: All Delta 1010 analog and
S/PDIF inputs may be used simultaneously for a total of 10 input channels.
Within your software application(s), the names of the Delta 1010 audio input
devices are:
PCM In 1/2 Delta-1010
PCM In 3/4 Delta-1010
PCM In 5/6 Delta-1010
PCM In 7/8 Delta-1010
S/PDIF In Delta-1010
Mon. Mixer Delta-1010
The PCM In devices allow recording a stereo stream directly from the specified
analog input pairs. The S/PDIF In device allows you to record a stereo stream
directly from the S/PDIF input. The Mon. Mixer device allows stereo recording
from the digital "monitor" mixer built-into the Delta 1010. The audio data
recorded from this device is the mix of input and output streams that is set up in
the Delta Control Panel software (see Delta 1010 Control Panel Software
section).
Note that all of the input devices are stereo. Your application software may break
these down further to "left" and "right" mono devices. Therefore you may see
them as "Left PCM In 1/2 Delta-1010, Right PCM In 1/2 Delta-1010", "Left
S/PDIF In Delta-1010, Right S/PDIF In Delta-1010", or "Left Mon. Mixer Delta-
1010, Right Mon. Mixer Delta-1010," etc. from within your recording software.
WINDOWS MME AUDIO OUTPUT DEVICES: All Delta 1010 analog and
S/PDIF outputs may be used simultaneously for a total of 10 output channels.
Within your software application(s), the names of the Delta 1010 audio output
devices are:
14