M-Audio Delta 1010 Manual page 9

5. With the Delta 1010 PCI card installed, restarting the computer will load the
Delta 1010 extension. You will be able to visually see the Delta extension icon
pass by as your system loads the extensions.
6. Go to the Apple menu |Control Panel | Sound. You should see the "built-in"
sound icon, plus the Delta icon if your Delta 1010 is properly installed. If your
music program does use ASIO, leave the Sound Manager driver set to "built-
in" for both Sound In and Sound Out. If your program does not use ASIO
(check your software's documentation) and you will be using the Sound
Manager to communicate with your Delta 1010, set Sound In and Sound Out
to "Delta." See the section "Hardware Settings Page" in the Delta 1010
"Control Panel Software" section for information on selecting Sound Manger
inputs and outputs.
Your Delta 1010 is now ready for audio input and output. To configure the Delta
for MIDI, you will need to have Opcode's OMS (Open Music System) installed
first. OMS is provided on the CD that came with the unit. Opening the OMS
2.3.7 folder and double-clicking on the "Install OMS 2.3.7" program will install
OMS in your system. To install the Delta MIDI driver once OMS is properly
installed:
1. Open the "Delta Products"folder on the driver CD, then the Delta 1010 Mac
folder. Locate the "Delta OMS Driver."
2. On your Macintosh hard drive, in your System folder, you will find an "OMS
Folder."Drag the Delta OMS Driver into the OMS Folder.
3. Restart your computer.
To Configure your Delta 1010 MIDI in OMS, go to the Apple Talk Control Panel
or Chooser under the Apple Menu, and make sure AppleTalk is turned off (this
is recommended, although OMS will sense that it is on and prompt you to turn it
off). If you are configuring OMS for the first time, follow these instructions to
configure OMS.
1. In the Opcode folder, which you will find on your hard drive, locate the OMS
Applications folder, then "OMS Setup." Double click on OMS Setup.
2. OMS will inform you that it has not yet been configured. Click OK.
3. The Create A New Studio Setup dialog box now appears. Click OK.
4. The "OMS Driver Search" box asks you to choose the port on which you've
attached the Deta MIDI (either Modem or Printer). DO NOT choose a port,
just click "Search." OMS begins Searching.
5. "OMS Driver Setup" shows the "Delta" MIDI in a list when OMS successfully
finds the driver. Click OK. OMS will now define (shows "Identifying") the
Delta output port.
showing the Delta's output port with a check box to the left of the port,
indicating that the port is enabled. Now click on OK.
6. Next, the "My Studio Setup" appears with a 'file save' dialog box over it. You
will now need to save your new Studio Setup before you can assign an
instrument to the Delta's MIDI output and input. Assign your instrument and
you are done. You may now exit OMS Setup by quitting the application.
The "OMS MIDI Device Setup" dialog box will appear
9