Patchbay/Router Page - M-Audio Delta 1010 Manual

Digital recording system

Hide thumbs Also See for Delta 1010:

Quick start manual (10 pages)

User manual (45 pages)

User manual (6 pages)

Table of Contents

necessarily be routed to any physical outputs (see Patchbay/Router Page). On the

Mac, these inputs are labeled "SM/ASIO," as these software streams will be

receiving their digital audio either from the Sound Manager or the ASIO driver,

depending on your selection.

Further to the right are more channels, labeled "H/W In S/PDIF" and "H/W In

1/2" through "H/W In 7/8." These mixer inputs are audio streams from the

physical Delta 1010 hardware inputs, hence the "H/W" at the front of each label.

These labels are consistent on both the Mac and PC.

PAN: Each mixer input may be individually panned anywhere in the stereo

output mix. A pan control is positioned directly under each input channel peak

meter and has the appearance of a small vertical pointer. To make a coarse

adjustment, click on the pan control with your mouse and drag it to the desired

position. For finer adjustment (in 1% increments), you may click on the pan

control to make it active, and then use the left/right or up/down cursor keys on

your computer keyboard. Either way, while the pan setting is being adjusted, its

value will appear numerically in the Master Volume's status box (below the

Master Volume Stereo Gang control) as a percentage from left pan to right pan:

-100% represents far left, +100% represents far right, and 0% represents the

center.

SOLO: Each mixer input channel has a "Solo" checkbox associated with it.

Clicking on and activating a Solo box will solo the selected channel by

essentially muting all other signals. When more than one channel has Solo

selected, all solo channels will be summed to the solo 'buss' (path), which is

what one might consider an 'in place' solo as opposed to a PFL, or pre-fader

listen (levels and pans still apply). Deactivating all solo boxes will return all

input channels to their previous mute/unmute states.

MUTE: Every mixer input channel has a "Mute" checkbox associated with it.

Clicking on and activating the Mute box will remove that signal from the stereo

buss. Deactivating the Mute box will add the signal back into the stereo buss.

STEREO GANG: All input channel pairs have a "Stereo Gang" capability.

Clicking on and activating the Stereo Gang checkbox will link (or "gang") the

left/right faders so that both channels may be adjusted together as a stereo pair.