Advertisement
2
Place the face, face down, on a soft, non-scratching surface. Install the 564 Electric mounting brackets onto
the back of the face.
3
Pull the electric fireplace out of the mantel (or built-in location). Attach the cove covers and face following the
directions below. Slide the fireplace back into place to complete the installation.
b
Lift the face up slightly, tilt
it forward and insert the
top hooks until the face
locks in place.
Page 6 of 6
564 SS / 564 E Rectangular Face
Remove and
a
discard the
hinge assembly
from the face.
a
Tilt the face back slightly and
insert the bottom hooks into
the slots on the fireplace.
7/19/07
Black 95400411
Nickel 95400413
c
Attach the lower 564 E bracket (and
b
shim). Use the nuts removed earlier and
one of the nuts included with this kit.
d
Attach the upper 564 E
bracket (and shim). Use the
nuts included with this kit.
Repeat steps "a" through
"c" for the opposite side.
Before installing the
e
face verify the lower
grill is centered.
Loosen the nuts and
adjust if necessary.
© Travis Industries, Inc.
Advertisement
