Overload Protector; Installing Or Removing Driver Bit Or Drill Bit - Makita 6095D Instruction Manual

ASSEMBLY
1
1. Tighten
2. Sleeve
3. Ring
12

Overload protector

The overload protector automatically cuts out to break the
circuit whenever heavy work is prolonged. Wait 20 - 30 sec-
onds before resuming operation.
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.

Installing or removing driver bit or drill bit

002113
Hold the ring and turn the sleeve counterclockwise to open
the chuck jaws. Place the bit in the chuck as far as it will go.
Hold the ring firmly and turn the sleeve clockwise to tighten
2 the chuck.
To remove the bit, hold the ring and turn the sleeve counter-
3
clockwise.