Mounting The Vx-6000D; Floor Mounting (Upright); Ceiling Mounting (Inverted); Adjusting The Projection Angle - Runco Video Xtreme VX-6000d Owner's Operating Manual

Installation
3.5
Mounting the
VX-6000d

Floor Mounting (Upright)

Ceiling Mounting
(Inverted)
Adjusting the Projection
Angle
3.6
Connections to the
VX-6000d and DHD
Controller
Connecting the DHD
Controller to the VX-6000d
There are several methods for mounting the projector. Depending on your chosen
installation, one method may be more suitable than another.
In typical front and rear screen installations, the projector can be mounted to a secure and
level surface such as a table or cart. Carts are useful when moving a projector during a
presentation or from site to site. If possible, lock the wheels when it's in position to prevent
it from being moved during a presentation.
For fixed installations, and for those that want the projector out of sight or have a limited
space for projector and audience, you can invert the VX-6000d and suspend it from the
ceiling using a specially-designed ceiling mount fixture.
Use only the Runco-approved ceiling mount kit designed for your
Note
projector. Install the mount kit according to the instructions
provided with it.
The projector can also be inverted and placed in an enclosure above and behind the
viewing area. Install four feet on the inside bottom surface of the enclosure on which the
projector can rest. A variety of materials can be used for this purpose (for example, rubber
crutch tips or turntable feet).
If the VX-6000d is ceiling-mounted and the screen is significantly lower than the projector,
you can tilt the projector at a slight angle by adjusting the ceiling mount.
If you do this, you may need to shift the image or apply keystone correction using the OSD
controls, to compensate. For detailed instructions, refer to Using the On-Screen Menus
on page 49.
Proceed as follows to connect the DHD Controller to the VX-6000d, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Route all cables through the cable opening at the bottom rear of the projector (see
Figure 2-1).
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
The VX-6000d is designed to receive only video input signals directly from the companion
DHD Controller/Processor. All signal sources should be connected to the appropriate
inputs on the rear panel of the DHD. The signal from the DHD is then output to the
VX-6000d projector through an RGB or DVI cable.
You CANNOT connect signal sources directly to the VX-6000d.
Note
They MUST be routed through the DHD Controller for proper
operation.
30 Runco VX-6000d Owner's Operating Manual