Roland RSS M-300 Owner's Manual page 85

fig.PopAuxSendField2Guide.eps
1
Pan slider
1
This adjusts the left/right panning of the signal sent to the
stereo-linked AUX/MTX in a range of L63–R63.
PAN LINK button
2
This turns the PAN LINK switch on/off. If PAN LINK is on, the
pan from the channel to MAIN
from the channel to the stereo-linked AUX/MTX.
The function buttons have the following operations:
[F1 (AUX 1-8)] Displays the sends to AUX1–8.
[F2 (MTX 1-4)] Displays the sends to MTX1–4.
[F3 (ALL ON) Turns on all send switches for each send field.
[F4 (ALL OFF) Turns off all send switches for each send field.
[F5 (UNITY) Sets the send level to 0.0 dB for the send field at
the cursor location.
[F8 (CLOSE)] Closes the popup.
2
will be linked with the pan
AUX send/MTX send
Setting all AUX/MTX send points in a
singe operations
1.
Press the [SEL] button of any channel
input channel.
2.
In the CHANNEL EDIT section's
press [DISP] to access the
3.
Press [F6 (ALL CH POINTS)] to access the ALL CH SEND
POINTS popup.
ig.ScrSendPoints_Guide.eps
1 Send point select buttons
These buttons select the send point for
from the following choices:
Selection Explanation
Keep Maintains the current setting.
PRE EQ Specifies pre-EQ.
PRE FD Specifies pre-fader.
POST FD Specifies post-fader.
4.
Use the send point select buttons to select the desired
send point.
5.
Press [F8 (OK)]; the AUX/MTX
step 4 will be assigned for all channels
operation, and the popup will close.
Pressing [F7 (CANCEL)] will cancel the operation and close
the popup.
CH1–32 to select an
AUX/MTX SENDS area,
AUX/MTX SENDS popup.
1
AUX1–8 or MTX1–4
send points you selected in
CH1–32 in a single
85