Roland RSS M-300 Owner's Manual page 24

Explanation of the panels
GATE area
5
fig.ChEdtGate.eps
In this area you can operate the gate/expander that is provided
for CH1–32.
• DISP button
This accesses the GATE/EXPANDER popup where you can
make detailed settings. The button will light red while the
popup is shown.
You can turn the gate/expander on or off by holding down
[SHIFT] and pressing [DISP].
This control is invalid for the following channels:
• AUX1–8
• MTX1–4
• MAIN L/R/C
COMP area
6
fig.ChEdtComp.eps
In this area you can operate the compressor that is provided on
CH1–32 and the limiter that is provided on AUX1–8,
and MAIN L/R/C.
• DISP button
This accesses a popup where you can make detailed settings.
This will access the COMPRESSOR popup for CH1–32, or the
LIMITER popup for AUX1–8,
button will light red while the popup is shown.
You can turn the compressor or limiter on or off by holding
down [SHIFT] and pressing [DISP].
PAN area
7
fig.ChEdtPan.eps
• PAN knob
For CH1–32, this adjusts the pan. For AUX1–8,
MAIN L/R, it adjusts the balance.
24
MTX 1–4,
MTX 1–4, and MAIN L/R/C. The
MTX 1–4,
AUX/MTX SENDS area
8
fig.ChEdtAux.eps
In this area you can adjust the send level from CH1–32 to the
AUX/MTX buses, or adjust the send level from AUX1–8, MAIN L/R/
C to the MTX buses.
• AUX1–AUX8 / MTX1–MTX4 buttons
These buttons select the AUX/MTX bus that will be the target
of the SEND LEVEL knob or the faders in SENDS ON FADER
mode.
You can turn the corresponding send switch on/off by holding
down [SHIFT] and pressing [AUX1]–[AUX8] / [MTX1]–[MTX4].
• DISP button
This button accesses the AUX/MTX SENDS popup where you
can make detailed settings. It will light red while the popup
is shown.
• SEND LEVEL knob
This adjusts the send level to the AUX/MTX bus selected by
the [AUX1]–[AUX8] / [MTX1]–[MTX4] buttons.
If an AUX or MAIN channel is selected, this will adjust the send
levels to MTX1–4.
If a MTX channel is selected, this will adjust the send levels from
AUX1–8 to MTX.
If AUX/MTX buses are stereo-linked, selecting the odd-
numbered AUX/MTX bus will let you adjust the send pan, and
selecting the even-numbered AUX/MTX bus will let you adjust
the send level.
• SENDS ON FADER button
This button turns SENDS ON FADER mode on/off. It will blink
if SENDS ON FADER mode is on.
"Using the SENDS ON FADER" (p. 43)