Connections And Installation; Connections On The Rear Panel; Unpacking - Icom IC-M710 Instruction Manual

CONNECTIONS AND INSTALLATION

■ Connections on the rear panel

Optional AT-130
q ANTENNA CONNECTOR (p. 20)
Connects a 50 ø HF band antenna with a 50 ø
matched coaxial cable and a PL-259 plug.
w GROUND TERMINAL
IMPORTANT! Connects to a ship's (or vehicle's)
ground. See p. 19 for details.
e ACC(1) and ACC(2) SOCKETS
See p. 17 for details.
r CLONE JACK
For Dealer use only.
t REMOTE SOCKET (p. 18)
REMOTE socket for General version.
y EXTERNAL SPEAKER JACK
Connects a 4 to 8 ø external speaker using a
monaural plug. This external audio is not muted by
the [SPEAKER] switch on the front panel.

■ Unpacking

Microphone (HM-180) ············································· 1
Microphone hanger ················································· 1
DC power cable (OPC-568) ···································· 1
Mounting bracket ···················································· 1
Bracket knobs ························································· 4
Flat washers (M5) ··················································· 4
CONNECTORS
DIN connector (8-pin for ACC1) ······························ 1
DIN connector (7-pin for ACC2) ······························ 1
Speaker plug ·························································· 1
Tuner connector ······················································ 1
Pins for tuner connector ········································· 4
Plates for tuner connector ······································ 4
e o
q
r t
w
u TUNER RECEPTACLE
Connects a control cable to an optional AT-130
tenna tuner
connection.
i DC POWER RECEPTACLE
Connects to a regulated 12–16 V DC power source
such as a 12 V battery or DC power supply using
the supplied DC power cable.
CAUTION:
tery. This will damage the transceiver.
o FUSE HOLDERS
Hold two 30 A fuses for + and _ terminals. Re-
place both fuses when one fuse is blown.
1 ⁄ "
4
NUTS AND BOLTS
Allen bolt (M6 × 50) ················································ 4
Self-tapping screws (M6 × 30) ································ 4
Nuts (M6; use 2 pcs. for each bolt) ························ 8
Flat washers (M6) ··················································· 8
Spring washers (M6) ·············································· 4
Self- tapping screws
(M3 × 16 for mic. hanger) ································ 2
FUSES
FGB 30 A (rear panel) ············································ 2
1205 (internal) ························································ 2
i
u
y
External
speaker
. A female connector is supplied for
DO NOT connect to a 24 V bat-
7
12 V battery
-
an
16