Panel Description; Front Panel - Icom IC-M710 Instruction Manual

■ Front panel

This function is not installed
in the IC-M710.
iM 710
MICROPHONE
POWER
q w
q MICROPHONE CONNECTOR (p. 17)
Accepts the supplied microphone or an optional
handset.
NOTE: No audio is output to the speaker when
the microphone or handset is not connected.
w POWER SWITCH [POWER]
Turns power ON or OFF.
e SPEAKER SWITCH [SPEAKER]
Turns the speaker ON or OFF.
• "è" appears in the display while the speaker is turned
OFF.
• Any external speaker connected to the rear panel is
not turned OFF.
r DISPLAY INTENSITY SWITCH [DIMMER]
➥ Turns the display backlighting ON or OFF.
➥ Push [FUNC], and then rotate the channel selector
dial to set the intensity level while pushing and hold-
ing [DIMMER].
t VOLUME CONTROL [VOLUME]
Adjusts the audio output level.
• No sound is output to the speaker when:
- A microphone is not connected.
- The [SPEAKER] switch is turned ON.
- The [SQL] switch is turned ON and no signal is being
received.
y GROUP CHANNEL SELECTOR [GROUP]
Selects groups in 20 channels steps and ITU ma-
rine channel groups.
NOTE: Some versions have no ITU channels.
TX FREQ
2182KHz
RESET
[ALARM] + [TX FREQ]
FOR ALARM TX
MODE
GROUP
VOLUME
SPEAKER
DIMMER
e r
t

PANEL DESCRIPTION

SSB RADIO TELEPHONE
AGC N B SQL
TUNE
CHANNEL
y
u
u ANTENNA TUNE SWITCH [TUNE] (p. 9)
Tunes the external tuner to the antenna.
• Activates only when an optional antenna tuner such as
Icom's AT-130 is connected.
NOTE: When selecting "Automatic tuning" in the
set mode, pushing this switch is not necessary
to tune the antenna. (p. 13)
i CHANNEL SELECTOR [CHANNEL] (p. 6)
➥ Selects an operating channel within the selected
channel group.
• User channels can be selected from 1 to 160 (max.)
in sequence regardless of the channel group.
➥ Changes the operating frequency after [CE] is
pushed (while "►"appears).
• The changed frequency is not programmed in this
way.
o FUNCTION SWITCH [FUNC]
After pushing activates the secondary functions of
these switches:
- [SQL] ········ Starts and stops scan (p. 7).
- [RX]··········· Sets RF gain (p. 10).
- [TX] ··········· Selects transmit power (p. 9).
- [CE]··········· Reprograms the channel name (p. 12).
NOTE: Function availability depends on vesions.
!0 CLARITY CONTROL [CLARITY] (p. 10)
Shifts the receive frequency ±150 Hz for clear re-
ception of an off frequency signal.
1 2 3
4 5 6
7 8 9
–
CE 0
FUNC
CH/F/REQ
RX TX
CLARITY
i o !0
2
2