Assembling The Fan For Ceilings 9 Feet Or Higher - Hunter Type 2 Owners And Installation Manual

3 • Assembling the Fan for Ceilings 9 Feet or Higher
Your Hunter fan comes with an optional 3" downrod extension pipe.
If you are hanging the fan on a ceiling lower than 9 feet tall and you
would like to use the enclosed optional downrod, follow Steps 4-1 –
4-5 on the following page.
3-1. To assemble fan to hang down from a flat or angled ceiling, place
the canopy and canopy trim ring around the adapter so that they
rest on the fan assembly.
3-2. Feed the wires from the fan through the downrod.
Note: Make sure all the wires are on the same side of the metal
dowel pin inside the dowrod.
3-3. Using the provided Allen wrench, loosen the setscrew on the
adapter to install the pipe and ball assembly. Note: When the
pipe and ball assembly is fully installed, 2-3 threads on the pipe
will still be visible; this is normal. Use the Allen wrench to securely
retighten the setscrew.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
WARNING: Do not carry or lift fan by canopy.
3-4. Using the provided Allen wrench, attach the scroll assembly to the
bottom of the downrod with the decroative screws.
3-5. Raise the fan and place the ball into the hanger bracket.
3-6. Align the notch on the ball with the indent in the hanger bracket.
(Rotate the fan until you hear the notch pop into place.
Go to 5 • Wiring the Fan.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Steps 3-5 – 3-6
6
45033-01 • 09/28/09 • Hunter Fan Company
Downrod
Canopy
Trim
Ring
Adapter
Allen Wrench
Step 3-4
Indent
Steps 3-1 – 3-3
Canopy
Scroll
Assembly
Setscrew
Decorative
Screws