Installing The Canopy And Canopy Trim; Ring - Hunter Type 2 Owners And Installation Manual

6 • Installing the Canopy and Canopy Trim Ring
6-1. Partially install two canopy screws (about 2 full turns) in the
hanger bracket.
6-2. Raise the canopy over the hanger bracket. Align partially installed
screws with key slots in canopy.
6-3. Twist canopy clockwise to secure.
6-4. Install third & fourth canopy screw in round hole on canopy.
Securely tighten all four screws.
6-5. Using both hands, push the canopy trim ring up to the top of the
canopy.
6-6. Twist canopy trim ring clockwise to secure the canopy.
Should you need to remove the canopy
trim ring, follow these steps:
1. Twist canopy trim ring counter
clockwise until it releases from
canopy.
Canopy
Step 6-5
Screw
9
45033-01 • 09/28/09 • Hunter Fan Company
Steps 6-1 – 6-2 Hanger Bracket
Canopy Trim
Canopy
Step 6-4

Ring

Step 6-3