Assembling And Hanging The Fan - Hunter 8 Installation And Operation Manual

Steps 3-1 – 3-2
Steps 3-4 – 3-5
Low Profile Washer
#8-32 x 3/4" Screw
3 • Assembling and Hanging the Fan
You can assemble your fan for standard mounting (steps 3-1 – 3-2)
or for low profile mounting (steps 3-3 – 3-5). Note: For low profile
mounting, the downrod is replaced with the low profile washer.
Downrod
3-1. To assemble fan to hang down from a flat or angled ceiling, insert
the downrod through the canopy and canopy trim ring. Feed the
Canopy
wires from the fan through the downrod.
3-2. Loosen the square head set screw on the adapter to install the
Canopy
pipe and ball assembly. Note: When the pipe and ball assembly
Trim Ring
is fully installed, 2-3 threads on the pipe will still be visible; this is
Set Screw
normal. Securely retighten the set screw with a wrench or pliers.
Skip to Step 3-6.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
3-3. Remove the set screw from the adapter.
3-4. Place the low profile washer (lip up) into the canopy. Be sure the
green ground wire is pointing up toward the ceiling.
3-5. Align the holes in the washer with the holes in the adapter.
Assemble securely with three #8-32 x 3/4" screws.
3-6. Raise the fan and place the hook on the ceiling plate through the
U-shaped hole in the rim.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Step 3-6
41968-01 • 04/10/07 • Hunter Fan Company
U-shaped

Hole