Table of Contents
Advertisement
8.
Note: If the teeth will not point downward
in any orientation, the blade is inside out.
Remove the blade and twist it right-side out.
9.
10.
Page 52
11.
Tracking
Page 19
12.
Support Bearings
13.
Step 6
Blade Tensioner
Step 6
Blade Center
Adjusting Blade
Page 25
Ripping
To make a rip cut:
1.
2.
3.
ON
Figure 52.
ALWAYS use a push stick when ripping
narrow pieces. Failure to follow these
warnings may result in amputation or
laceration injuries!
NEVER place fingers or hands in the line of
cut. If you slip, your hands or fingers may
go into the blade and may be cut.
Figure 52
Advertisement
Table of Contents
