Table of Contents
Advertisement
Assembly
Some sheet metal parts
may have sharp edges
that can cause minor cuts.
Please use care while han-
dling them.
The bandsaw is heavy and awkward to lift
onto the stand. Get assistance from another
person when lifting.
To assemble the bandsaw:
1.
Note: Only hand-tighten the stand fasteners
during these initial steps. Once the stand is
completely assembled you will be instructed
to fully tighten all fasteners.
Figure 8.
Figure 8
2.
Figure 9
Figure 9.
3.
Note: Adjust the feet so that they are approxi-
mately the same height—this will make level-
ing the stand easier in a later step.
Figure 10.
Figure 10
Advertisement
Table of Contents
