Table of Contents
Advertisement
REMOTE
CONTROL
MODEL
LR4455
PREPARATION
FOR USE
Batteries are provided with this remote, but you must install
them before nsing the remote.
BAIWERY
REPLACEMENT
Your remote comes with batteries installed. When its effec-
tive operating range becomes noficzably shorter, replace
the batteries with two high-quality, alkaline, _
AAA bat-
teries.
NOTE: When the remote does not receive power from its
baueries, it may set itself to Zenith video equipment
('IV,
Zenith VCR, and Zenith cable-TV decoder) default codes.
If you have "taught" it to operate other equipment, it will
forget what it was taught.
To decrease this possibility, replace the batteries promptly,
and do not remove the old batteries until you are ready to
insert new ones. The batteries normally have enough power
to save the information even if they do not have enough
power to operate the remote.
.
2.
Remove
the battery
compartment
cover.
PUSH
DOWN tab and PULL OUT from top.
Insert new batteries
as indicated
by the diagram
inside
the compartment.
Be careful
to place
the
batteries
correctly.
If the polarities
(the + and - )
are reversed,
irreparable
damage
to the remote
control
can occur.
3.
Replace
the cover by inserting
the tab on the bot-
tom of the cover into its housing.
Snap the cover
into place.
NOTES:
•
Be careful not to place heavy objects on top of the remote
control buttons. Prolonged accidental operation of the
remote control will shorten battery fife.
•
If you will not use the remote control for a month or more,
remove the batteries. Battery leakage can cause damage
to the remote control.
•
Zenith is not responsible for damage caused by battery
leakage.
1.
1)
e
Advertisement
Table of Contents
