Error Messages; Procedure To Exit Ypao - Yamaha RX-V471 Owner's Manual

Optimizing the speaker settings automatically (YPAO)
Error messages
If any error message is displayed during the measurement, resolve the problem and perform YPAO again. Error message can be confirmed and controlled by viewing both a TV
monitor and the front display.
Procedure to exit YPAO
TV monitor Front display
2
3
4
Check the contents of error message, and then press ENTER.
Press the cursor key (i>) to select "EXIT (Exit)" from the following
choices, and then press ENTER.
Choices: PROCEED(Proceed) (E-5, E-9 only), "RETRY(Retry)," "EXIT(Exit)"
Press the cursor key (v) to select "Exit (Exit)" from the following
choices, and then press ENTER.
Choices: Start (Start), Exit (Exit)
Remove the YPAO microphone.
Cause and remedy for each error message
E-1 :No Front SP Front speakers are not
(E-1 :NO FRNT SP) detected.
E-2:No Sur. SP Either of surround
(E-2:NO SUR SP) speakers is not detected.
Follow "Procedure to exit YPAO" to exit YPAO, turn off the unit, and then check the speaker connections. After removing problems, turn on the unit, and
then perform YPAO again.
Keep the room quiet and select "RETRY (Retry)" in step 2 of "Procedure to exit YPAO" to restart YPAO for an accurate measurement. Selecting
E-5:Noisy The noise is too loud. "PROCEED (Proceed)" allows you to continue measuring, but may not achieve the optimal results.
(E-5:NOISY) We recommend selecting "RETRY (Retry)" or "EXIT (Exit)" to retry YPAO again from the beginning.
E-7:No MIC The YPAO microphone has
Connect the YPAO microphone to the YPAO MIC jack firmly and select "RETRY (Retry)" in step 2 of "Procedure to exit YPAO" to restart the measurement.
(E-7:NO MIC) been removed.
E-8:No Signal The YPAO microphone Connect the YPAO microphone to the YPAO MIC jack firmly and select "RETRY (Retry)" in step 2 of "Procedure to exit YPAO" to restart the measurement.
(E-8:NO SIGNAL) cannot detect test tones. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center.
E-9:User Cancel The measurement has Select "PROCEED (Proceed)" in step 2 of "Procedure to exit YPAO" to resume the measurement. Select "RETRY (Retry)" to restart the measurement from
(E-9:CANCEL) been canceled, first.
E-10:lnternal Err. An internal error has Follow "Procedure to exit YPAO" to exit YPAO, turn off and on the unit. Perform YPAO again. If this error occurs repeatedly, contact the nearest authorized
(E-10:INTERNAL) occurred. Yamaha dealer or service center.
En
29